Hitachi Koki USA HV-F202SCL User Manual Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 17
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
SHEET
3
17
DF022-4PE-
S
1
21 3 4
F
E
D
C
B
A
F
E
D
C
B
A
21 3 4
DWG.
No.
E400234503
3. Specifications
(1) Imaging device (sensor type) 1/1.8-inch progressive scan interline CCD (x 3 sensor)
- Indication lens category 1/1.8 inch
Effective pixels (Active area) 1600 (H) x 1200 (V) (x 3 sensor for RGB) : Resolution
Pixel size 4.4 μm square lattice
- scanning area (Pixel area) 7.04mm (H) x 5.28mm (V), Diagonal 8.80mm (1/1.8 inch)
- Readout type, Transfer type progressive scan, Interline transfer
(2) scanning mode full pixel sequential scan
(3) scanning frequency Horizontal : 37.5kHz / Vertical : 29.95Hz / Pixel : 72.0MHz
(4) Optical system 1/1.8-inch F1.8 prism with IR cut filter
Graph is described later.
(5) Lens mount C mount Mount surface projection less than 4.0mm
(6) Flange focal distance 17.526 mm (Air conversion)
(7) Sensitivity 2000 lx, F5.6, light source halogen lamp temp.: 3200K
Shutter : 1/30s, Gain 0dB
(8) Minimum illumination 12 lx, Video Level 50%, Gamma = 0.45
F1.8, Shutter : 1/30s, Gain +12dB
(9) Gamma 0.45 / 1.0 / LUT (Look Up Table : user customizable)
(10) Gain Manual : 0 to 12 dB / AGC : 0 to 12 dB (with limit setting)
(11) White balance Manual / One-push Auto / Continuance Auto
(12) Video output
CaemraLink Version 1.13 standard
Base configuration ( only D.OUT 1 )
Medium configuration ( using D.OUT 1 with D.OUT 2 )
Control : Original
(13) Video output format Base configuration 24bit (R:8bit, G:8bit, B:8bit)
Table is described later.
(14) Quantization level information Maximum data : 255 (8bit), 1023 (10bit), 4095 (12bit)
Video 100% white : 255 (8bit), 1023 (10bit), 4095 (12bit)
Video 0% black : 0, Minimum data : 0
(Lens selection guideline)
Use the lens less than 4.0mm as the projection item from the lens flange surface.
To obtain a good picture image by high resolution and few chromatic aberration, it is
necessary to choose an appropriate high resolution 3CCD type lens.
When using lens other than 1/1.8 type, there may be vignetting or insufficiency of light
around the image or occurrence of flare in the image, in this case combinational lens
selection is necessary.
Page view 2
1 2 3 4 5 6 7 8 ... 16 17

Comments to this Manuals

No comments